Gear Boxes, Motors, & Drives

MOTOR, 1/2HP, 1750RPM, 90VDC

Motor, 1/2HP, 1750RPM, 90VDC This motor is used on APACKS Conveyors & Cappers   Use the E-PAK Part Number...

View Product Details

COUPLING, FLEXIBLE SHAFT FC-20-3/4

Used on elevator pre-feeders, snap cappers, turntables, and timing screws   Used with Spider:   1001-055

View Product Details

ACTUATOR, 1000LB HT. 12" ST 230VAC

Used for electric power height adjustment of the 4 Station Capper.

View Product Details

DUFF NORTON:MOTOR RUN CAP AT 230VC

Power Height Motor "Run Cap", 230 VAC 15 MFD Required for each 115Vac 4 Station Capper Power Height unit (1087-040)

View Product Details

DUFF NORTON:MOTOR RUN CAP AT 115VC

Power Height Motor "Run Cap", 115 VAC 50 MFD Required for each 115Vac 4 Station Capper Power Height unit (1087-038)

View Product Details

ACTUATOR, 1000LB HT. 12" ST 115VAC

Used for electric power height adjustment of the 4 Station Capper.

View Product Details

DC Motor Drive, 230VAC Board KBIC

For DC motor control on cappers, conveyors, and similar machines. Board controls min/max and acceleration of motor speed range. Plug in resistors from 1/100 to 1 HP (see chart below). Horse Power Resistor is NOT included...

View Product Details

DC MOTOR DRIVE, HORSE POWER RESISTORS, FOR KBIC BOARDS

DC Motor Control Board Resistor Each KBIC Board needs a horse power resister, sized for the motor.

View Product Details

DC MOTOR DRIVE, 120VAC BOARD KBIC

DC Motor Control Board For DC motor control on cappers, conveyors, and similar machines. Board controls min/max and acceleration of motor speed range. Plug in resistors from 1/100 to 1 HP (see chart below). Horse Power...

View Product Details

WELDMENT, JACK MOUNT STUD

WELDMENT, JACK MT. STUD Used on power height jacks for cappers

View Product Details

TUBING, NYLAFLOW 1/8" HIGH PRESSURE

Tubing, Nylaflow 1/8" High Pressure Used on Cappers for grease line Sold by the foot

View Product Details

GEAR REDUCER, 5:1 56C FACE INLINE

Gear Reducer, 5:1 56C Face Inline Used on 4 Station Cappers for the Spindle Motor * Do Not mix Lubricants in the reducer.  If oil is needed, drain the gear box and replace all of the oil. Always check for proper oil...

View Product Details

MOTOR, 1/2 HP 40 RPM 90V GEAR

Motor, 1/2HP, 40RPM, 90VDC Motor used on the 3 Station Cappers (Gripper Belt Drive) . Replacement oil for the Gear box: “Mobil Glygoyle Synthetic Gear Oil”, “Fully Synthetic Gear...

View Product Details

MOTOR, 1/2 HP 90V

MOTOR, 1/2 HP 90V Used for a 3 Station Capper (Spindle Drive)

View Product Details

MOTOR, 1/2 HP 90RPM

MOTOR, 1/2 HP 90RPM Used on 4 Station Cappers (Gripper Belts)

View Product Details

MOTOR, 1/2HP 1750RPM 90VDC

Motor, 1/2HP, 1750RPM, 90VDC Motor drive for Conveyors and 4 Station Capper, (sometime the 3 Staion Capper) (Spindle Drive).

View Product Details